Filter
Top Products
Toll Call Prefix
Code:
#402
Description:
Phone companies recognize long distance calls in either of two
ways: a telephone number preceded by 0 or 1 plus an area code or a tele-
phone number preceded only by an area code. Use this procedure to tell the
PARTNER Plus system which method your phone company uses.
Valid Entries:
✓
1
= 0
or 1 plus the area code
2 = Area code only (0 or 1 not necessary)
Programming Steps:
1
. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The
display reads:
Toll Call Prefix
1 0/1 + AreaCd
2. To change the toll call prefix, press [ Next Data ] until the appropriate setting
appears. For example,
Toll Call Prefix
2 Area Code Only
System Password
Code:
#403
Description:
Identifies the 4-digit password that lets a user override Outgoing
Call Restrictions (#401). You can also use the password with Night Service
(#503 and #504) to restrict after-hours dialing.
Valid Entries: Any 4 digits
Entering the password allows you
Considerations:
If you assign a password using this procedure, you must enter
to override several dialing restric-
tions. See appendix B for a sum-
the password when-turning Night Service (#503) on or off.
mary of dialing restrictions.
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The
display reads:
Set Password
Data----
If a password has previously been set, it will appear on the display.
2. Enter or change the password using the dial pad. For example, to set the
password to 5747, press [ 5 ] [ 7 ] [ 4 ] [ 7 ] . The display reads:
Set Password
Data5747
To remove a password, press [ Remove ]
✓
= Factory Setting
To go to the next procedure: [ Next Proc ]
Togo to a specific procedure: [ # ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc ]
(where XXX is the procedure number)
To return data to the factory setting: [ Remove ]
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-19