Filter
Top Products
System Time
Code: #103
Description:
The time, in 24-hour military-style notation
Valid Entries:
Any time
Even though you enter the time in
Programming Notes:
Enter the time in 24-hour notation, commonly known as
24-hour notation, it appears on
display phones as a.m. and p.m.
military time. In this scheme, the hours of the day are 0000 (12 midnight) to
after you program it.
2359 (11:59 p.m.). Since each time must have four digits, use leading zeroes
when necessary. For example, to set the time to 9:00 a.m., enter [ 0 ] [ 9 ] [ 0 ] [ 0 ] .
To set the time to 4:45 p.m., enter [ #
] [ 1 ] [ 0 ] [ 3 ] .
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 0 ] [ 3 ]. The
display reads:
System Time
Data 0000
2. Enter a new time in 24-hour notation. For example, to set the time to 2:15
p.m., press [ 1 ] [ 4 ] [ 1 ] [ 5 ]. The display reads:
System Time
Data 1415
Number of Lines
Code: #104
Description:
Use this procedure as a quick way to assign the same number of
outside lines to all extensions when first setting up the system. You can assign
all or only some of the outside lines to all extensions. If you assign fewer lines
than the total number of lines in the system, the system assigns the lines in
order. For example, if you assign 5 lines but there are 8 outside lines, the sys-
tem assigns lines 1 through 5 to all extensions.
Valid Entries:
0
through 8 lines
✔
2 lines per 206 module installed
Considerations:
To add or delete specific lines on specific extensions, use procedure #301,
Line Assignment.
If you later add more lines to the system, use procedure #301 to assign them
to extensions rather than this procedure, which returns the Line Assignment
(#301 ), Automatic Line Selection (p. 4-3), and Line Ringing Options (p. 4-4)
to the factory settings.
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 0 ] [ 4 ]. The
display reads:
Number Of Lines
8 Lines
2. Enter the correct number of lines. For example, to tell the system there are
7 outside lines, press [ 7
] . The display reads:
Number Of Lines
7 Lines
System Programming 3-5