Filter
Top Products
2. WIRING
2-3
c) Adjust the length of each core considering its location on the terminal board
TB801.
d) Trim each wire (except coaxial wire) considering its location on the terminal
board.
e) Trim the shield leaving 200 mm and attach crimp-on lug FV5.5-4.
f) Remove insulation of each wire by about 6mm.
g) Fabricate the coaxial cable as shown right.
4. As shown in the figure below, side the clamping gland, flat washer, gasket and flat
washer on the signal cable.
5. Fold back armor and pass the flat washer as shown in the figure below. Cut and
trim the armor around the flat washer.
Passing clamping gland, washer and gasket on the signal cable
Shield wire
Fold back shield.
Conductor
6
Wire
Coaxial cable
20 mm
Shield
Armor
Outer sheath
Inner sheath
460 mm
5 mm
Shield
FV5.5-4
200mm
Coaxial cable
Vinyl cable
360
59
14
Gasket
Vinyl sheath
Clamping gland
Flat washer
Cut and trim armor.