Filter
Top Products
2. WIRING
2-5
Fabricating power cable TPYCY-2.5
1. Open the left side cover on the antenna unit with the hex wrench.
2. Fabricate the cable as shown below. Use TPYCY-2.5 (Japan Industry Standard)
cable or equivalent.
Fabricating the power cable TPYCY-2.5
3. At the power cable gland on the antenna unit, unfasten the clamping gland and
remove gasket, flat washers and blind lid.
4. As shown in the figure below, slide the clamping gland, washers and gasket onto
the power cable. Fold back the armor by 5mm, and then pass it through the two
flat washers.
Passing clamping gland, washers and gasket on power cable TPYCY-2.5
5. Coat the screw part of the clamping gland with silicone sealant and tighten it.
6. Pass the power cable behind the terminal block, and then pass it through the lock-
ing wire saddle.
25 mm
5 mm
FV2-4
Sheath
Armor
A
nti-corrosive
Vinyl sheath
Approx. 170 mm
Gasket
Vinyl sheath
Clamping gland
Flat washer
Cut and trim armor.