Filter
Top Products
4. INSTALLING OPTIONAL EQUIPMENT (for RADAR)
4-4
7. Attach the clamps on the plastic cover and then attach the cover to the GYRO
CONVERTER board as shown in the figure below. Insert cables to the clamp
EDS-1, respectively.
Attaching plastic cover for GYRO CONVERTER board
8. Close the radar processor unit.
4.1.2 Connection of external power supply
An external power supply is necessary when the repeater signal is step-by-step type
and the step voltage is below 20V or output voltage is less than 5W.
1. Cut jumper wire JP1 on the GYRO CONVERTER board when an external power
supply is used.
1
1
4
1
12
1
3
1
2
1
3
1
12
1
5
1
7
1
3
Screw
M4X8
3 pcs
Plastic cover
Insert cables to these
clamp.
Clamp EDS-1
Clamp CKS-10-L
Clamp CKS-13-L