Filter
Top Products
2. WIRING
2-22
Slide switch
Set the slide switch to “ON” (default setting). This setting automatically powers the
monitor unit on or off according to the DVI signal input. The power switch of the mon-
itor unit is inoperative.
Note: The OFF position provides control of the monitor unit power with the power
switch of the monitor unit.
How to open the [INSTALLATION SETTING] menu
Turn off the monitor unit. While you hold the DISP key, press the BRILL key to turn on
the monitor unit. Press and hold the DISP key for more than five seconds.
Note: When the [DVI PWR SYNC] slide switch is ON, turn on the connected external
equipment while you press the DISP key to turn on the monitor unit.
2.6 Power Supply Unit
Wire the unit as shown in the interconnection diagram.
Relay
XK1: Connect output line.
TB1: Connect control line.
K2: Connect
Cable clamp: Clamp the armors of the cable.
input line.
Thermal relay
(W)
(v)