Filter
Top Products
xi
Compaq ProLiant 3000 Servers Setup and Installation Guide
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: A-FRNT.DOC Last Saved On: 1/12/99 3:01 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Any surface or area of the equipment marked with these
symbols indicates the presence of a hot surface or hot
component. If this surface is contacted, the potential for injury
exists.
WARNING: To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
Power Supplies or Systems marked with these symbols
indicate the equipment is supplied by multiple sources of
power.
WARNING: To reduce the risk of injury from electrical
shock, remove all power cords to completely disconnect
power from the system.
Rack Stability
WARNING: To reduce the risk of personal injury or damage to
the equipment, be sure that:
■ The leveling jacks are extended to the floor.
■ The full weight of the rack rests on the leveling jacks.
■ The stabilizing feet are attached to the rack if it is a single
rack installations.
■ The racks are coupled together in multiple rack installations.
■ A rack may become unstable if more than one component is
extended for any reason. Extend only one component at a
time.