Filter
Top Products
3-16
Rack-Mountable Server Installation
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: D-CH03.DOC Last Saved On: 1/12/99 1:24 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Attaching the Mounting Bracket Slide
Assembly to the Rack
WARNING:
To reduce the risk of personal injury or damage to
the equipment, be sure that the rack leveling feet are extended to
the floor and support the full weight of the rack. Each rack must
be level and stable. Racks that are not coupled together require
the installation of stabilizers. This
must
be done before you
perform any work on the rack.
Measuring with the Template
The template provided with the server offers an easy and reliable way to
properly position the server in the rack. Use the tabs on the template to suspend
it from the lower hole of a two-hole set of perforations in the vertical side rails.
Pencil mark the attachment points for the mounting bracket assemblies, the
cage nuts for the face-plate thumbscrews, and the top of the server. Use the tick
marks on the rack side rails to ensure level installation of the server. See
illustrations and instructions printed on the template.
IMPORTANT:
Determine the server's place in the rack before you install
the mounting bracket assemblies. To remind you of the proper placement of
the server in the rack, refer to the Rack Builder report you printed when you
planned your rack configuration. Always mount the heaviest item on the
bottom of the rack and work from the bottom to the top.
1. Starting at the bottom of the rack, or at the top of a previously mounted
component, measure the screw hole locations for the server's mounting
bracket assemblies. Pencil mark the locations on the outside of the rack.
Do this on both the front and the back of the rack.