Filter
Top Products
4-17
Compaq ProLiant 3000 Servers Setup and Installation Guide
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: E-CH04.DOC Last Saved On: 1/12/99 1:28 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
4. Insert the Simplex Enable board.
Figure 4-14. Installing the Simplex Enable board
CAUTION:
The SCSI backplane board must have either a Duplex
Enable board or a Simplex Enable board installed in order for the
SCSI bus to be terminated properly. If neither of these boards is
installed, the service LEDs of all drives will light as a warning.
5. Install drive cage. See section “Installing Drive Cage.”