A-6
Regulatory Compliance Notices
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: H-APPA.DOC Last Saved On: 1/12/99 1:31 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Laser Devices
The CD-ROM drive contains a laser device. All Compaq systems equipped
with a laser device comply with safety standards, including International
Electrotechnical Commission (IEC) 825. With specific regard to the laser, the
equipment complies with laser product performance standards set by
government agencies as a Class 1 laser product. The product does not emit
hazardous light; the beam is totally enclosed during all modes of customer
operation and maintenance.
Laser Safety Warnings
WARNING:
To reduce the risk of fire, bodily injury, and damage
to the equipment, observe the following precautions:- Do not
operate controls, make adjustments, or perform procedures to a
laser device other than those specified herein or in the CD-ROM
drive installation guide.- Allow only Compaq Authorized Service
Technicians to repair the laser equipment.
Compliance with CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and
Drug Administration implemented regulations for laser products on August 2,
1976. These regulations apply to laser products manufactured from August 1,
1976. Compliance is mandatory for products marketed in the United States.
Compliance with International Regulations
All Compaq systems equipped with CD-ROM drives comply with appropriate
safety standards including IEC 825.