Filter
Top Products
B-1
Compaq ProLiant 3000 Servers Setup and Installation Guide
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: I-APPB.DOC Last Saved On: 1/4/99 5:20 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Appendix B
Power Cord Set Requirements
The power cord set meets the requirements for use in the country where you
purchased your equipment. The voltage selection switch allows you to select
the appropriate line voltage for your server.
Power cord sets for use in other countries must meet the requirements of the
country where you use the server. For more information on power cord set
requirements, contact your Authorized Compaq Dealer.
General Requirements
The requirements listed below are applicable to all countries:
■ The length of the power cord must be at least 6.0 feet (1.8 m) and a
maximum of 12 feet (3.7 m).
■ The power cord set must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power cord
will be used.
■ The power cord set must have a minimum current capacity and nominal
voltage rating of 10 A/125 volts AC, or 10A/250 volts AC, as required
by each country’s power system.
■ The appliance coupler must meet the mechanical configuration of an
EN60320/IEC 320 Standard Sheet C13 Connector, for mating with the
appliance outlet on the computer.