Filter
Top Products
3-28
Rack-Mountable Server Installation
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: D-CH03.DOC Last Saved On: 1/12/99 1:24 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Figure 3-16. Attaching the cable management arm to the rear brace of the rack
Attaching the Optional
Cable Support
The optional cable support attached to the rear of the rack on both sides. All
cables to and from the server are tied to this support, which allows the server
cables to stretch from the right rear of the server across to the cable channel on
the other side of the rack, where the other cables are bundled in the cable
channel.
The cable support is needed only if you intend to route cables from one side of
the rack to a cable channel on the other side of the rack.
Attach the cable support to both rear braces of the rack using four
M6 x 1.0-12L Phillips screws.