Filter
Top Products
Installing and Configuring the PassageWay
Service Provider
2-3
Upgrading the PassageWay Service
Provider or PassageWay Solution
This section applies to users who have an earlier version of the PassageWay
Service Provider or PassageWay Solution installed. If you do not have an
existing version of the PassageWay Service Provider or PassageWay Solution
installed, refer to the previous section, “New PassageWay Service Provider
Users.”
If you have an earlier version of the PassageWay Service Provider software or
PassageWay Solution installed on your PC, perform the following steps:
1. Read the section “PassageWay Service Provider Components” to
make sure that you have all of the PassageWay Service Provider
components.
2. Read the section “PassageWay Service Provider Requirements” to
make sure that you have the required hardware and software to run
the PassageWay Service Provider.
3. Read the section “Before You Begin” to make sure that you have the
necessary information to set up the PassageWay Service Provider.
4. Install the PassageWay Service Provider by performing the
procedures in the section “Installing the Software.”