Filter
Top Products
Installing and Configuring the PassageWay
Service Provider
2-6
PassageWay Service Provider
Requirements
The PassageWay Service Provider requires the hardware and software listed
below. Install the required hardware and software before installing the
PassageWay Service Provider software. Note that system performance may
be adversely affected by lower system speeds and lower memory capacities.
an IBM-PC compatible or PS/2
®
-compatible PC with the following
hardware:
an 80386 or higher processor
an available serial port
a minimum of 4 MB of RAM
a 3.5-inch, 1.44-MB, high-density diskette drive
a hard disk with at least 4 MB of space available
a VGA or better monitor
a Windows-compatible pointing device (a mouse or trackball is
recommended)
NOTE:
You must have an available serial port in your PC that is
dedicated to the PassageWay Service Provider. The
PassageWay Service Provider cannot share a serial port with
other devices.
If all the serial ports in your PC are already in use, you must
purchase an additional serial port or free up an existing serial
port to use with the PassageWay Service Provider. Consult
Appendix A for more information on choosing a suitable serial
port for the PassageWay Service Provider.