Filter
Top Products
Troubleshooting
4-4
Problem 2: You are unable to dial from a TAPI-compliant application.
Perform the following steps:
1. Verify that the PassageWay Service Provider was installed and
configured properly.
2. If you are using Windows 95 or Windows 3.1 or later, close all
telephony applications, and then run Connect.
3. From the Setup menu in Connect, select Test Adapter, and follow
the instructions on the screen.
If the PassageWay Adapter Test fails, note the error number and refer
to the next section, “Troubleshooting Connect.”
If all tests pass successfully, run the TAPI-compliant application.
Problem 3: Your TAPI-compliant application does not display caller ID
information for incoming intercom calls.
The PassageWay Service Provider does not provide caller ID information for
incoming intercom calls.
Problem 4: When you place an outgoing, ringing call on hold via your
TAPI-compliant application, the call is dropped (that is, disconnected).
You should not place outgoing, ringing calls on hold. The PassageWay
Service Provider will disconnect these calls.
Problem 5: When you conference an outgoing, ringing call via your
TAPI-compliant application, the outgoing call is dropped, but your
application indicates that the conference exists.
You should not conference outgoing, ringing calls. The PassageWay Service
Provider will disconnect these calls. Even though the call was dropped, your
application may incorrectly indicate that the call is part of the conference.