Filter
Top Products
Installing and Configuring the PassageWay
Service Provider
2-29
32. Choose the OK button.
The View README File dialog box appears. If you want to view the
Readme file now, make sure the check box is selected. (This check
box is selected by default). If you do not want to view the Readme file
now, make sure the check box is not selected.
33. Choose the Finish button.
If the Readme file check box was selected, the Notepad window
appears, displaying the contents of the Readme file. Proceed to
Step 34.
If the Readme file check box was not selected, the About To Restart
Windows message box appears. Proceed to Step 35.
34. When you are finished reading the Readme file, select
Exit
from the
File menu to close the Notepad window.
NOTE:
If you have any other Notepad windows open, you must close
all of them now. The installation will not continue until all
Notepad windows are closed.
The About To Restart Windows message box appears.
35. Choose the OK button.
The Install dialog box appears.
36. Remove the diskette from the diskette drive (if you are installing from
diskette), and choose the OK button.
Depending on your version of Windows, either the system or Windows
restarts.
The PassageWay Service Provider is now installed.