Filter
Top Products
2.2 Installing the System Console
If you are using a V105 terminal as the system console, connect it to the cabinet as described in the following procedure. If
you are using another terminal as the system console, be sure it is configured with the following parameters.
VT300/7 terminal emulation
●
9600 EIA and auxiliary (Aux) baud rate●
odd parity●
one stop bit●
To install a V105, follow these steps.
Locate the terminal data cable (part number AW-B15201-25) in one of the cartons shipping with the system.1.
Connect the terminal data cable to the V105 terminal's SES1-EIA port and to the cabinet's Console port (J315),
(See Figure 2.12). After the cable is connected, tighten its connector screws with a flat-blade screwdriver.
2.
An additional terminal can be connected to the Auxiliary Console port (J316).
For additional information, see FTX Operating System: Peripherals
Configuration (RXXX).
Figure 2.12. Connecting the V105 Data Cable
Chapter 2