Filter
Top Products
Chapter 4
Booting the System
This chapter describes how to boot the system.
Boot the system by performing the following steps.
Verify that cabinet components are seated properly by checking that their thumbscrews are fully tightened.
1.
Verify that the flash cards are fully inserted in the bridge cards in slot 0 of each PCI card cage.2.
Power up the system console.3.
Initiate the automatic boot process by turning on:4.
For DNCP Series 400 (PA-8500) --the MAIN and PCI power switches, See Figure 4.1.●
For DNCP Series 400-CO (PA-8500) -- the MAIN, ACU, and PCI power switches See Figure 4.2.●
Figure 4.1. System Power Switches for the DNCP Series 400 (PA-8500)
Figure 4.2. System Power Switches for the DNCP Series 400-CO (PA-8500)
Chapter 4