Filter
Top Products
To change the SCSI identification on a T800-series tape drive, first power down the tape
drive. The SCSI identification is read by the system when the tape drive is powered up. If
you change the SCSI identification display after power-up, the new identification will not be
registered by the tape drive. Any attempts to access the tape drive will result in an
application error.
If the tape drive is the last drive in the daisy chain, verify that the single-ended SCSI terminator (part number
JC-005TRM) is installed in the lower port on the rear of the tape drive. If the terminator is not installed, connect it
to the lower port and securely clip it to the tape drive, See Figure 3.10 .
4.
Install only a single-ended SCSI terminator on the tape drive. Do not install a differential terminator, as it could damage
the tape drive and/or SCSI PCI card.
Figure 3.10. SCSI Terminator: Daisy-Chained T800-Series
Chapter 3
]