Filter
Top Products
Connect the female end of the V105 power cord to the V105 power connector and the male end to an AC wall
outlet (See Figure 2.14).
4.
Figure 2.14. Connecting the V105 Power Cord
Power up the V105 by pressing the power switch on the front of the terminal to the ON position (See Figure 2.15) .
When the V105 passes its self-test, its screen displays PASS . If this does not occur, turn off the V105 power
switch, check its power cord connection, and then power it up again. If it still does not pass the self-test, refer to the
FTX Operating System: DNCP Series 400/400-CO (PA-8500) Operation and Maintenance Guide (RXXX) for
V105 troubleshooting information.
5.
Figure 2.15. V105 Power Switch
Chapter 2
]