Filter
Top Products
5-8 If an Error Message Appears
99
Chapter 5 What to Do If
is too low for the media thickness specified on the com-
puter. The heads move to a location where you can op-
erate the height-adjustment lever. Adjust to the displayed
height, then press
.
[SHEET SET ERROR SET AGAIN]
was pressed even though no media is loaded.
Press any key to clear the error. Load media and pull
back the loading lever, then press
.
Transparent media was loaded even though [SHEET
TYPE] is set to [OPAQUE].
Press any key to clear the error. Set the [SHEET TYPE]
menu item to [CLEAR], then reload the media.
☞ p 75 "Using Transparent Media"
The positioning of the loaded media is displaced to
the left.
Press any key to clear the error. Reload the media at the
correct position, then press
.
The loaded media is too small.
Press any key to clear the error. Replace with media of
usable size.
The platen is dirty.
Press any key to clear the error. The machine cannot sense
the width of the media because of soiling. Clean the
platen.
The media clamps are mounted at the wrong loca-
tions.
Press any key to clear the error. The media clamps are
intended to clamp the edges of the media. Reattach them
at the correct locations.
[TEMPERATURE IS TOO HIGH]
The temperature of the location where the machine
is installed has risen above the ambient tempera-
ture at which the machine can operate.
Operation cannot be continued. Switch off the sub power.
Bring the installed location to a temperature at which
operation is possible (20 to 32˚C), then turn on the power.
[TEMPERATURE IS TOO LOW]
The temperature of the location where the machine
is installed has fallen below the ambient tempera-
ture at which the machine can operate.
Operation cannot be continued. Switch off the sub power.
Bring the installed location to a temperature at which
operation is possible (20 to 32˚C), then turn on the power.
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge
of the specified type.
A cartridge was inserted with too much force.
Remove the cartridge to clear the error. Insert and re-
move cartridges slowly and gently, one at a time.
[WRONG WIDTH UNDER 1220 (or 48)]
The width of the loaded media is too narrow.
Press
to clear the error. Replace with media of
usable size.