Filter
Top Products
2-2 Loading and Cutting Off Media
34
Chapter 2 Operation
➎
While pulling the media to keep it taut, adjust the position of the end of the media.
Position so that the end of the media reaches the paper pipe (that is, so that it reaches a position where it
can be taped in place).
Media gauge
As shown in the figure, place on the feed-side roll
media and use as a guide for positioning the me-
dia on the take-up side.
As you position the left and right edges, follow the
procedure
➏
on the following page to tape the
media in place.
Bring this surface into
contact with the side of
the roll.