Filter
Top Products
97
Chapter 5 What to Do If
5-7 If a Message Appears
These are the main messages that appear on the machine's
display to prompt correct operation. They do not indicate
any error. Follow the prompts and take action accordingly.
[1■ 2■ 3■ 4■ ...]
Only a small amount of ink remains. Replace the car-
tridge indicated by the flashing number with a new car-
tridge.
[CLOSE THE COVER]
Close the front cover and the left and right side covers.
For safety, the carriage doe not operate while a cover is
open.
[DO NOT USE MEDIA CLAMPS]
Make sure the media clamps have been removed. The
media clamps cannot be used when the height of the
print heads is set to "Low." (Using them may cause mal-
function.) After verifying, press
.
[EMPTY DRAIN BOTTLE]
Detach the drain bottle from the machine, discard the
discharged fluid, then reinstall the drain bottle on the
machine. Press
to continue. This message ap-
pears before operations that discharge a large amount of
ink.
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the
drain bottle, then press
.
[NOW HEATING...]
Wait until the preheater and print heater reach the pre-
set temperature. Printing starts when the preset tempera-
ture is reached.
You can stop printing by holding down
for one
second or longer while this is displayed.
Pressing
makes printing start immediately, with-
out waiting to reach the preset temperature.
[PRESS THE POWER KEY TO CLEAN]
This appears when the machine has been unused for
about one month. Switch on the sub power once a month.
☞ p 61 "When Not in Use for a Prolonged Period"
[REMOVE SOL CL]
Remove the cleaning cartridge indicated by the flashing
number. This message appears at times such as during
head cleaning.
[REMOVE SOL CRT.]
Remove the ink cartridge indicated by the flashing num-
ber. This message appears at times such as during head
cleaning.
[SET SOL CRT.]
Insert the ink cartridge indicated by the flashing num-
ber. This message appears at times such as during car-
tridge replacement.
[SET SOLCL-LIQUID]
Insert the cleaning cartridge indicated by the flashing
number. This message appears at times such as during
head cleaning.
[SHEET NOT LOADED PRESS SETUP KEY]
Load media and press
. This message appears
when an attempt to perform a printing test was made
while no media was loaded.
[TIME FOR MAINTENANCE]
It is time to clean the heads using the cleaning kit. After
verifying, press
.
☞ p 55 "Cleaning the Heads Using the Cleaning Kit"
[TIME FOR WIPER REPLACE]
It is time to replace the wiper. After verifying,
press
.
☞ p 59 "Replacing the Wipers"