Filter
Top Products
2-2 Loading and Cutting Off Media
33
Chapter 2 Operation
5.
Fasten the media to the paper pipe.
➊
➀ Go to the front of the printer.
➁ While holding down the media by hand to
keep it from slipping out of place, flip the load-
ing lever to the rear.
➂ Pull the media to a position next to the pa-
per pipe.
➋
Close the cover.
➌
➀ Set the AUTO switch off.
➁ Switch on the power.
➍
While pulling the media to keep it taut, adjust
the position of the end of the media.
Position so that the end of the media reaches
the paper pipe (that is, so that it reaches a posi-
tion where it can be taped in place).
Feed unit