Filter
Top Products
68
Chapter 4 Feature Reference
4-3 Optimizing Printing to Match Media Thickness
Adjusting Head Height to Match Media Thickness
Procedure
➊
Press .
Press
several times.
➋
Press .
➌
Move the lever.
➍
Press .
Press
.
Use
to go back to the original screen.
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print heads. When you are using such media, adjust the head height to "High."
Note that the height of the heads cannot be determined by just the thickness of the media.
When the height is set to "Low," the media clamps cannot be used. Except in special cases, the "Low" setting
should never be used. Doing so may cause the heads to strike the clamps and become damaged.
MENU
HEAD HEIGHT
HEAD HEIGHT
MIDDLE MIDDLE
Height-adjustment lever
Move firmly, until it stops.
High
Middle (standard)
Low (normally not available
for use)
W 2600 mm
SETUP SHEET