Filter
Top Products
90
Chapter 5 What to Do If
The Printer Unit Doesn't Run
Is the power switched on?
Switch on the printer's main power, then press the sub
power switch and make sure the POWER light comes
on.
If the
light on?
Printing is not performed when the
light is not
on. Pull back the loading lever, close the front cover,
and press
.
Is the front cover open?
Close the front cover.
Is the top menu displayed?
If the top menu isn't displayed, printing doesn't start even
when data is sent from the computer. To go to the top
menu, press
, then
press
.
Is the
light on?
When the
light is on, operation is paused. To
resume, press
. The light goes dark and
printing resumes.
Has ink run out?
When printing data is sent while the screen shown in
the figure is displayed, a message appears and a warn-
ing beep sounds. At the same time, operation pauses.
When the ink cartridge is re-
placed with a new one, printing
starts.
Is a message displayed on the screen?
☞ p 97 "If a Message Appears"
☞ p 98 "If an Error Message Appears"
Is the cable connected?
Connect the cable securely.
The Media Take-up or Feed System Doesn't Run
Is the power switched on?
Switch on both the printer's main power switch and the
power switch for the take-up and feed units. To perform
take-up and feed automatically during printing, also make
the setting for the AUTO switch.
Is the cover closed securely?
The take-up and feed units do not operate unless the
cover is securely closed.
5-1 The Machine Doesn't Run
Is media loaded correctly?
Make sure the media is passed through the guide roller
and dancer rollers correctly.
The Dryer Doesn't Warm Up
Is the main power switch for the dryer turned on?
Turn on the main power switch for the dryer.
Are the menu settings enabled?
You can set the dryer on or off using the menu for the
printer. Make sure the [DRYER] menu item is set to "ON."
Also, the operation method changes according to the
setting of the [PREHEATING] menu item.
☞ p 82 "Switching the Dryer On and Off"
☞ p 83 "Determining How the Preheater, Print Heater,
and Dryer Operate"
Is the temperature of the room too low?
Use the machine in an environment where the tempera-
ture is 20 to 32˚C (68 to 90˚F).
Is the power supply the right voltage?
This machine requires 200 to 240 V power. Please note
that it will not operate correctly at a lower voltage.
The Preheater and Print Heater Don't Warm Up
Is media loaded?
The preheater and print heater do not warm up to the
preset temperature when the
light is dark (un-
less the default setting has been changed). Load media,
press
, and wait for the machine to warm up.
☞ p 83 "Determining How the Preheater, Print Heater,
and Dryer Operate"
Is the temperature of the room too low?
Use the machine in an environment where the tempera-
ture is 20 to 32˚C (68 to 90˚F).
Is the power supply the right voltage?
This machine requires 200 to 240 V power. Please note
that it will not operate correctly at a lower voltage.
W 2600 mm
1
_
2
■
3
■
4
■
5
■
6
■
7
■
8
■
9
■
10
■
11
■
12
■