Filter
Top Products
44
A
S
> Pressing and releasing the A button saves the Set Point and advances to SET DEPTH ALARM VALUE (if set ON) or
SET ELAPSED DIVE TIME ALARM (if set OFF).
> Depressing both buttons for 2 seconds reverts to the TIME/WET screen.
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.
SET DEPTH ALARM VALUE
Factory set for 100 FT, the DEPTH ALARM VALUE can be set from 30 to 330 FT (9 to 99 M) in increments of 10 FT (3 M).
After saving ON as the setting for DEPTH ALARM ON/OFF, the SET DEPTH ALARM VALUE screen appears with the Set
Point flashing. Information displayed includes (Fig. 41) -
• Alpha graphics DEEP and AL
• Depth Alarm Set Point flashing, with MAXIMUM and FEET (or METERS) icons
> Depressing and holding the S button scrolls upward through the Set Points at a rate of 8 per
second until released.
> Pressing and releasing the S button momentarily and repeatedly (< 2 sec each time) steps up-
ward through the Set Points 1 at a time.
> Pressing and releasing the A button saves the Set Point and/or advances to SET ELAPSED
DIVE TIME ALARM.
> Depressing both buttons for 2 seconds reverts to the TIME/WET screen.
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.
Fig. 41 - Set Depth
Alarm Value