Filter
Top Products
47
INSIGHT
A
S
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.
SET RESERVE TIME ALARM VALUE
Factory set for 5 minutes, the RESERVE TIME ALARM VALUE can also be set from 1 to 30 minutes
in increments of 1 minute.
After accepting ON as the setting for RESERVE TIME ALARM ON/OFF, the SET RESERVE TIME
ALARM VALUE screen appears with the Set Point flashing. Information displayed includes (Fig. 45) -
• Alpha graphics RES and AL
• Reserve Time (min) Set Point flashing, with MINUTES icon
> Depressing and holding the S button scrolls upward through the Set Points from 1 to 30 at a rate of
8 Set Points per second until released.
> Pressing and releasing the S button momentarily and repeatedly (< 2 sec each time) steps upward
through the Set Points 1 at a time.
> Pressing and releasing the A button saves the Set Point and/or advances to SET DECO ALARM.
> Depressing both buttons for 2 seconds reverts to the TIME/WET screen.
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.
SET DECO ALARM ON/OFF
Factory set ON, the DECO ALARM can also be set OFF. When set OFF, the Alarm will not sound
upon entry into Decompression.
Fig. 45 - Set Reserve
Time Alarm Value