Sherwood CR2709 Scuba Diving Equipment User Manual


 
51
INSIGHT
A
S
> Pressing and releasing the S button steps through the Rate Set Points.
> Pressing and releasing the A button saves the Set Point and advances to SET DEEP STOP.
> Depressing both buttons for 2 seconds reverts to the TIME/WET screen.
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.
SET DEEP STOP ON/OFF
Deep Stop (described in more detail later in the No Deco Dive Mode section) is a completely optional
safety stop that, when set ON, will trigger upon descent past 80 FT (24 M) and display a recommended
Stop to be taken at 1/2 the calculated Max Depth of that dive.
Factory set OFF, the DEEP STOP feature can also be set ON. When set OFF, the Deep Stop screens
will not appear during dives.
To access SET DEEP STOP while viewing the SET 3 GO TO screen, press/release the A button (4
times) until the Set screen appears (Fig. 51) -
• Alpha graphic DS (indicating Deep Stop)
• Set Point graphic ON (or OFF) flashing
> Pressing and releasing the S button toggles between ON and OFF
> Pressing and releasing the A button saves the Set Point and reverts to the SET 3 GO TO screen.
> Depressing both buttons for 2 seconds reverts to the TIME/WET screen.
• Operation reverts to the TIME/WET screen if neither button is pressed in 2 minutes.
Fig. 51 - Set Deep Stop