Filter
Top Products
Cable layout
161
857-164342 / Rev.C
PC Transceiver to transducer(s)
This cable connects the PC Transceiver board to one or tow
transducers. The cable must be run in steel conduits. Use a
junction box only if required.
W806
Revision: A
Two separate, or
one dual frequency
transducer
6
8
2
7
9
4
PCT
Inner
screen
Outer
screen
Pins 1, 3
and 5 are not
connected.
Water temperature sensor
(Only available with Simrad Combi
transducers 38/200 and 50/200.)
Junction Box (1:1)
High frequency
Low frequency
Note:
1) All transducer cables must be run in
steel conduits. Use flexible conduit closer
to the transceiver.
2) Cable shields must be connected to
the plug housing.
3) Cable shields must be connected to
ship's ground in the junction box.
not
Plug housing
PC Transceiver to transducer(s)
Female 9-pin
D-pin connector
on PCT Board
5
1
6
9
Conductors 2 x N mm2 for each transducer
Screen Overall braided
Voltage 60V
Max. diameter Set by the plugs
The conductor diameter “N” depends on the chosen transducer.
Normal value for single beam transducers is 1.5 mm
2
.Special
transducer cable is available from Simrad..