Filter
Top Products
Operational procedures
39
857-164342 / Rev.C
Power on/off
Use the following procedures to switch the EQ60 echo sounder
on and off.
Power on
It is assumed that the echo sounder’s hardware and software are
properly installed and configured.
1 Switch power on.
2 Observe the hardware test messages and operating system
start-up messages.
- It takes a couple of minutes before the echo sounder
window appears on the display.
The echo sounder memorises all its settings when power is
switched off. Hence, pinging will start immediately if the echo
sounder was pinging when you switched power off.
If pinging does not start you must check the settings in the
following dialogue boxes:
• Operation
• Layout
• Transceiver Settings
• Transceiver Installation
If you are not successful you should use this procedure:
1 Check the Transceiver Installation dialogue box.
2 All frequency channels must be properly installed.
3 Select Factory settings in the Options menu.
Power off
To switch off the EQ60 echo sounder, observe the following
procedure.
1 Select Shutdown on the
File menu.
2 Allow the computer to close all the echo sounder software
applications.
3 Switch off power.
4 Switch off the power on the General Purpose Transceiver
and other peripherals (if any).
Related topics
→ Operation, page 97