Filter
Top Products
Operational procedures
53
857-164342 / Rev.C
10 Click OK when prompted to reboot the system.
Software upgrade procedure
Use this procedure if you wish to reinstall the software, or
receive a new CD-ROM with a software upgrade.
1 Connect a keyboard to the echo sounder., or start the
On-screen keyboard application (normally located under
Accessories and Accessibility).
2 Connect a CD ROM unit to the parallel port.
3 Switch on the echo sounder.
4 Insert the software CD.
5 Observe the Installation program dialogue box open.
6 Press Update installation.
7 Allow the echo sounder installation to run. Follow the
instructions provided.
8 When requested, enter the license number.
- This number is located on the CD cover. This number
is unique for each individual echo sounder.
Un-installation procedure
Use this procedure if you need to remove all the echo sounder
software from the computer. Note that all data in the EQ60
directory will be erased.
1 Power up the computer.
2 Insert the EQ60 CD-ROM.
3 Observe the Installation program dialogue box open.
4 Press Uninstall.
5 Allow the echo sounder un-installation program to run.
Follow the instructions provided.
Software on a third party computer
The EQ60 may operate with a locally purchased computer,
provided that this computer meets the minuimum requirements
defined by Simrad. If in doubt, consult your dealer.
To install the software and operate the echo sounder from a third
party computer, you will need to set up the computer correctly,
and you will need a separate licence number.
How to set up the computer
This procedure assumes that you are familiar to the operating
system. DO NOT attempt to set up the computer if you are
unfamiliar with the settings described here, but consult your
dealer.