Filter
Top Products
Simrad EQ60
74
857-164342 / Rev.C
Vessel L og - Check this box if you want to transmit VesselLog
datagrams. This datagram is required by BI 500 and is
automatically generated based on the vessel speed.
You will normally transmit all the datagrams when operating
EQ60 together with BI 500. If you do not use the BI 500, do not
export any datagrams.
The Echogram, Echo trace and Vessel log datagrams are
identical to the corresponding datagrams transmitted by the
Simrad EK500 echo sounder.
Distance
Use this parameter to (re)set the internal log distance counter.
The current value of the log distance counter is shown at the
time the BI 500 dialogue box was opened.
Echogram
You can here specify the layout of the echogram datagram.
No. of Surface Values - this value defines the number of
surface based echogram values to be filled into the echogram
datagram. This number should be 500 (default) when operating
with the BI 500 post-processing software.
No.ofBottomValues-this value defines the number of bottom
based echogram values to be filled into the echogram datagram.
This number should be 150 (default) when operating with the BI
500 post-processing software.
Surface Range - Click this button to enter the Surface Range
dialogue box. Here you specify the operating range for the
surface echogram.
Bottom Range - click this button to enter the Bottom Range
dialogue box. Here you specify the operating range for the
bottom echogram.
Ethernet
These parameters are used to define the Ethernet connection
with the BI 500 computer.
The Remote UDP Port and the Remote IP Address specified
must correspond to the UDP port number and Internet address
used by the BI 500 computer.
Related topics
→ Surface Range, page 110
→ Bottom Range, page 77
→ Navigation Interface, page 95