Filter
Top Products
P/N 06160D DCN6409 Teledyne API Model 465M O
3
Monitor Instruction Manual - Page 49
5. Enter the IP address. The Subnet mask displays automatically based on the
IP address; if desired, you may change it. On a local network, you can leave the
Default gateway blank (all zeros). Click Next.
6. Click the Assign button and wait several seconds until a confirmation message
displays. Click Finish.
7. Select the device from the main window list and select Ping from the Tools
menu. The Ping Device dialog box shows the IP address of the selected unit.
8. From the Tools menu, click the Ping button. The results display in the Status
window. Click the Clear Status button to clear the window so you can ping the
device again.
9. Click the Close button to close the dialog box and return to the main window.
NOTE
If you do not receive “Reply” messages, make sure the unit is
properly attached to the network and that the IP address assigned
is valid for the particular network segment you are working with.
If you are not sure, check with your systems administrator.