Filter
Top Products
24
4
r PLOTTER MODEq MARK MANIPULATION
(4)-1 Registering marks
Å Registration of marks from the
Plotter Menu screen
Navigational reference points, such as the destination point and turning
points, can be indicated with marks. These marks will be helpful for desti-
nation navigation and route navigation.
They can be registered in two ways: from the Plotter Menu screen or on the coast-
line screen.
q Press the [MENU] key.
The Main Menu screen will appear.
w Select “Plotter Menu” using the [UP] or [DOWN] key and press the [SET] key.
The Plotter Menu screen will appear.
e Select “Mark Enter/Erase” using the [UP] or [DOWN] key and press the [SET]
key.
The Mark Enter/Erase screen will appear.
r Select “ENTER” using the [UP] or [DOWN] key and press the [SET] key.
The system is ready for mark registration and the first digit of the latitude setting
field is highlighted in yellow.
t Select digits in the latitude setting field using the [LEFT] or [RIGHT] key, enter a
numerical value and specify the latitude direction, N (North) or S (South), using
the [UP] or [DOWN] key, and then press the [SET] key.
The first digit of the longitude setting field is highlighted in yellow.
y Select digits in the longitude setting field using the [LEFT] or [RIGHT] key, enter
a numerical value and specify the longitude direction, E (East) or W (West),
using the [UP] or [DOWN] key, and then press the [SET] key.
One of 12 marks will appear at the bottom of the screen.
u Select the desired mark using the [UP] or [DOWN] key and the desired color of
the mark (seven colors selectable) using the [LEFT] or [RIGHT] key, and then
press the [SET] key.
The character list will appear at the bottom of the screen and END is highlight-
ed in yellow.
i Select a character from the character list to name the mark, and then press the
[SET] key.
Each time the [SET] key is pressed, the selected character is entered in the
comment field.
* A comment such as a user-defined mark name of up to eight characters can be
entered in each comment field.
o Select “END” and press the [SET] key.
The mark is now registered.
* Repeat steps t to o as required.
ENTER
LAT 34°25.123N
LON 135°10.456E
ERASE ALL
5
Enter the latitude and longitude
and press the [SET] key.
Select the desired mark and
press the [SET] key.
Enter the mark name and
press the [SET] key.
5
¡Mark Enter/Erase screen ¡Selecting the mark to be
used
¡Entering the user-defined
mark name
5
CLR
SET
SET
CANC
ADJ
SEL
80.0FT
MARK ENTER/ERASE
ENTER
LAT 34°25.123N
LON 135°10.456E
ERASE ALL
CLR
SET
SET
CANC
TYPE
COL
80.0FT
MARK ENTER/ERASE
ENTER
LAT 34°25.123N
LON 135°10.456E
Point1
ERASE ALL
CLR
SET
SET
CANC
80.0FT
MARK ENTER/ERASE
SEL
" # END
ABCDEFGHIJKLMNOPQRS
TUVWXYZ 0123456789
abcdefghijklmnopqrs
tuvwxyz
.,
!#$%&
´
-()