Filter
Top Products
PowerLogic™ PM5100 series user guide Chapter 7—Alarms
© 2014 Schneider Electric All Rights Reserved54
• Low priority—if a low priority alarm occurs, the alarm LED and the alarm icon blink
only while the alarm is active. No alarm message is displayed.
• No priority—if an alarm is set up with no priority, no visible representation appears on
the display. Alarms with no priority are not entered in the alarm Log.
If multiple alarms with different priorities are active at the same time, the display shows
the alarms in the order they occurred.
When a pickup event occurs, the active alarm list appears. Press “Detail” to see more
event information. See “Alarm Setup” on page 54 for more information.
Alarm Setup
Evaluation of all alarms is temporarily suspended while alarm setup screens are
displayed. Evaluation resumes immediately upon exit from alarm setup screens.
To set up standard alarms:
1. Navigate to Maint > Setup.
2. Enter the setup password (default is “0000”), then press OK.
3. Press Alarm.
Use the directions in the following sections to set up alarms.