Filter
Top Products
PowerLogic™ PM5100 series user guide Chapter 7—Alarms
© 2014 Schneider Electric All Rights Reserved 55
Setting Up 1-Second Alarms
To set up a standard alarm:
1. Press 1-Sec. The 1-second
alarm Select screen appears.
2. Press ▼ and ▲ to scroll
through the list of standard 1–
second alarms.
3. Press Edit to select an alarm to
be configured.
4. Press Edit to select Pickup
Setpoint.
5. Press + to increment the active
digit through the numerals 0-9.
6. Press to enter the selected
value for the active digit and
move to the next digit to the left.
7. Continue until all values are
selected, then press OK to
enter the selected number for
the pickup setpoint.
8. For power factor alarms (Lead
PF, True; Lag PF, True; Lead
PF, Disp; and Lag PF, Disp)
press
▼ to select PU Set Point
Lead/Lag, then press Edit. For
other alarms, skip to Step 11.
9. Press + and - to scroll between
Lead and Lag.
10. Press OK to set the pickup set
point lead or lag.
11. Press
▼and follow Steps 4 to
7 for Pickup Time Delay and
Dropout Setpoint.
12. For power factor alarms, press
▼to select DO Set Point
Lead/Lag and follow Steps 10
and 11. For other alarms,
proceed to Step 14.
13. Press ▼and follow Steps 4 to
7 for Dropout Time Delay.
14. Press ▼ to select Enable, then
press Edit.
15. Press + and - to scroll between
Yes and No.
16. Press OK to enable or disable
the alarm.