Filter
Top Products
© 2011 Schneider Electric. All Rights Reserved.
PowerLogic
TM
Series 800 Power Meter 63230-500-225A2
Chapter 3—Operation 3/2011
20
E-INC (Incremental Energy Interval) Setup
THD Calculation Setup
VAR/PF Convention Setup
1. Perform steps 1 through 5 of the SETUP MODE
Access procedure on page 11.
2. Press
###: until ADVAN (advanced setup) is
visible.
3. Press ADVAN.
4. Press
###: until E-INC (incremental energy) is
visible.
5. Press E-INC.
6. Enter the INTVL (interval). Range is 00 to 1440.
7. Press OK.
8. At the SETUP MODE screen, continue
programming additional setup features or
press
1; until you are asked to save changes.
9. Press YES to save the changes.
).#2%.%2'9
/+
).46,
PLSD110197
1. Perform steps 1 through 5 of the SETUP MODE
Access procedure on page 11.
2. Press
###: until ADVAN (advanced setup) is
visible.
3. Press ADVAN.
4. Press
###: until THD is visible.
5. Press THD.
6. Select the THD calculation: FUND or RMS.
7. Press OK.
8. At the SETUP MODE screen, continue
programming additional setup features or
press
1; until you are asked to save changes.
9. Press YES to save the changes.
4($#@KBTK@SHN.
ET.$
PLSD110206
1. Perform steps 1 through 5 of the SETUP MODE
Access procedure on page 11.
2. Press
###: until ADVAN (advanced setup) is
visible.
3. Press ADVAN.
4. Press
###: until PF is visible.
5. Press PF.
6. Select the Var/PF convention: IEEE or IEC.
7. Press OK.
8. At the SETUP MODE screen, continue
programming additional setup features or
press
1; until you are asked to save changes.
9. Press YES to save the changes.
0&#N.UD.SHN.
HDDD
PLSD110209