Filter
Top Products
© 2011 Schneider Electric. All Rights Reserved.
PowerLogic
TM
Series 800 Power Meter 63230-500-225A2
Chapter 3—Operation 3/2011
26
View the Meter Information
Read and Write Registers
View the Meter Date and TIme
1. Press ###: to scroll through the Level 1 menu
until you see MAINT.
2. Press MAINT.
3. Press DIAG (diagnostics) to open the HEALTH
STATUS screen.
4. On the HEALTH STATUS screen, press
METER (meter information).
5. View the meter information.
6. Press
###: to view more meter information.
7. Press
1; to return to the HEALTH STATUS
screen.
NOTE: The wrench icon and the health status code
display when a health problem is detected. For
code 1, set up the Date/Time (see “DATE Setup”
and “TIME Setup” on pages 11 and 12). For other
codes, contact technical support.
-%4%2).&/
0-
2%3%4
3.
-/$%,
6
6
PLSD110094d
1. Press ###: to scroll through the Level 1 menu
until you see MAINT.
2. Press MAINT.
3. Press DIAG (diagnostics) to open the HEALTH
STATUS screen.
4. On the HEALTH STATUS screen, Press REG
(register).
5. Enter the password (the default is 0000).
6. Enter the REG. (register) number that contains
the data you want to monitor.
The register content will be displayed in both
HEX (hexadecimal) and DEC (decimal) values.
7. Press
1; to return to the HEALTH STATUS
screen.
NOTE: For more information about using registers,
see Appendix C—Using the Command Interface
on page 83.
272%')34%2
(%8
$%#
2%'
/+
PLSD110194
1. Press ###: to scroll through the Level 1 menu
until you see MAINT.
2. Press MAINT.
3. Press DIAG (diagnostics) to open the HEALTH
STATUS screen.
4. On the HEALTH STATUS screen, press
CLOCK (current date and time).
5. View the date and time.
6. Press
1; to return to the HEALTH STATUS
screen.
0-$!4%4)-%
0-
-).
3%#
45%3
(/52
6
6
PLSD110327