Simrad ROBERTSON AP45 Marine Instruments User Manual


 
Page 5-34 Robertson AP45 Autopilot
Installation
Simrad Robertson AS
Egersund - Norway
Panel mounting
Make a panel cut-out of 126 x 102 mm.
Use the supplied fastening device to
secure the unit to the panel. See Fig.
5-41
Fig. 5-41 Panel mounting
Bracket mounting
Mount two of the bracket halves to the RI35.
Temporarily bolt together the other two halves of the bracket to the
first two halves.
Hold the RI35 in place by hand and mark the 4 holes for the fixing
screws on the mounting surface.
Remove the RI35, drill the 4 mounting holes in the mounting surface.
Unbolt the temporarily fitted bracket halves and secure them to the
mounting surface using the self-tapping screws.
Assemble the complete bracket again and adjust the RI35 to best
viewing angle and tighten up the mounting bracket bolts.
Fig. 5-42 RI35 Bracket mounting