Filter
Top Products
Robertson AP45 Autopilot
Start-Up procedure / Commissioning
Simrad Robertson AS
Egersund - Norway
Page 6-3
will be shown in the information
display instead of each parameter
that has got a special value. This is
done to avoid that the parameters
are re-selected by a mistake.
To continue without further
changing the special value: Press
the WEATHER button.
To re-select the factory parameter
setting:
• Enter the Debug mode as
described on page 7-5. (Press
hidden button + Weather
button).
• Step through the entire debug
loop until you find:
• Press - button repeatedly until
alarm sounds and display shows:
• By pressing the ALARM button
and cancel the alarm the
complete set of factory settings
are re-selected.
The text in the Information Display
can be presented in four different
languages.
Select desired language by pressing
the RUDDER and WEATHER
button simultaneously. The display
shows one of the following
languages: ENGLISH, FRANCAIS,
ESPANOL, NORSK.
Press the + or - button until the
desired language is shown in the
display.
Fig. 6-1
AP45 Installation loop
PROGRAM: V_R_
RUNTIME: -------------H
DATA FAILURE !
CHECK SETTINGS
Select language
* ENGLISH *
F, E, D, N: +/-