xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config vlan add
Description This command allows the user to add ports to the port list of a
previously configured VLAN. Additional ports may be specified as
tagging, untagging, or forbidden. The default is to assign the ports
as untagging.
Parameters
<vlan_name 32> − The name of the VLAN to which to add or
delete ports.
add − Specifies which ports to add. The user may also specify if
the ports are:
tagged − Specifies the additional ports as tagged.
untagged − Specifies the additional ports as untagged.
forbidden − Specifies the additional ports as forbidden.
<portlist> − A range of ports to add to the VLAN. The port list is
specified by listing the lowest slot number and the beginning port
number on that slot, separated by a colon. Then the highest slot
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies slot
number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4 −
in numerical order.
advertisement [enabled | disabled] − Enables or disables GVRP
on the specified VLAN.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add 4 through 8 of module 2 as tagged ports to the VLAN v1:
DES-6500:4#config vlan v1 add tagged 2:4-2:8
Command: config vlan v1 add tagged 2:4-2:8
Success.
DES-6500:4#
config vlan delete
Purpose Used to delete ports from a previously configured VLAN.
Syntax
config vlan <vlan_name 32> delete <portlist>
Description This command is used to delete ports from the port list of a
previously configured VLAN.
Parameters
<vlan_name 32> − The name of the VLAN from which to delete
ports.
<portlist> − A range of ports to delete from the VLAN. The port list
is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
122
