xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config command_prompt
Switch.
default – Entering this parameter will return the command
prompt to its original factory default setting.
Restrictions
The reset command will not alter the configured command
prompt, yet the reset system command will return the command
prompt to its original factory default setting.
Only administrator-level users can issue this command.
Example usage:
To configure the command prompt:
DES-6500:4#config command prompt Trinity
Command: config command prompt Trinity
Success.
Trinity#
config greeting_message
Purpose Used to configure the greeting message or banner for the
opening screen of the Command Line Interface.
Syntax
config greeting_message {default}
Description This command is used to configure the greeting message or
login banner for the opening screen of the CLI.
Parameters default – Adding this parameter will return the greeting command
to its original factory default configuration.
Restrictions
The reset command will not alter the configured greeting
message, yet the reset system command will return the
greeting message to its original factory default setting.
The maximum character capacity for the greeting banned is 6
lines and 80 characters per line. Entering Ctrl+W will save the
current configured banner to the DRAM only. To enter it into the
FLASH memory, the user must enter the save command.
Only administrator-level users can issue this command.
Example usage:
To configure the greeting message:
23
