xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
create ipif
to be created. The address and mask information can be specified
using the traditional format (for example, 10.1.2.3/255.0.0.0) or in
CIDR format, (10.1.2.3/8).
<vlan_name 32> − The name of the VLAN that will be associated
with the above IP interface.
secondary – Enter this parameter if this configured IP interface is
to be a secondary IP interface of the VLAN previously specified.
secondary interfaces can only be configured if a primary interface
is first configured.
state [enabled | disabled] − Allows the user to enable or disable
the IP interface.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create the primary IP interface, p1 on VLAN Trinity:
DES-6500:4#create ipif p1 ipaddress 10.1.1.1 Trinity state enabled
Command: create ipif p1 ipaddress 10.1.1.1 Trinity state enabled
Success.
DES-6500:4#
To create the secondary IP interface, s1 on VLAN Trinity:
DES-6500:4#create ipif p1 ipaddress 12.1.1.1 Trinity secondary state enabled
Command: create ipif p1 ipaddress 12.1.1.1 Trinity secondary state enabled
Success.
DES-6500:4#
config ipif
Purpose Used to configure an IP interface set on the Switch.
Syntax
config ipif <ipif_name 12> [{ ipaddress <network_address> |
vlan <vlan_name 32> | state [enabled | disabled]} | bootp |
dhcp]
Description This command is used to configure the System IP interface on the
Switch.
Parameters <ipif_name 12> - Enter the previously created IP interface name
desired to be configured.
ipaddress <network_address> − IP address and netmask of the IP
interface to be configured. The address and mask information can
be specified using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
135
