xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
9
NETWORK MONITORING COMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
show packet ports
<portlist>
show error ports
<portlist>
show utilization [ports | cpu]
show stack information
clear counters
ports <portlist>
clear log
show log index <value_list>
enable syslog
disable syslog
show syslog
create syslog host [<index 1-4> | all] {severity [informational | warning | all] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state
[enabled | disabled]}
config syslog host <index 1-4> {severity [informational | warning | all] | facility [local0
| local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enabled |
disabled]}
config syslog host all {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enabled | disabled]}
delete syslog host [<index 1-4> | all]
show syslog host [<index 1-4>]
config system_severity [trap | log | all] [critical | warning | information]
show system_severity
Each command is listed, in detail, in the following sections.
show packet ports
Purpose Used to display statistics about the packets sent and received by
the Switch.
Syntax
show packet ports <portlist>
Description This command is used to display statistics about packets sent and
received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
above. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type
of frame associated with these packets.
58
