xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
reconfig
Purpose Used to connect to a member switch, through the commander switch
using telnet.
Syntax
reconfig [member_id <value 1-32> | exit]
Description This command is used to reconnect to a member switch using telnet.
Parameters member_id <value 1-32> - Select the ID number of the member
switch to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To connect to the MS, with member id 2, through the CS, using the command line interface:
DES-6500:4#reconfig member_id 2
DES-6500:4#
Command: reconfig member_id 2
config sim_group
Purpose Used to add candidates and delete members from the SIM group.
Syntax
config sim_group [add <candidate_id 1-100> {<password>} |
delete <member_id 1-32>]
Description This command is used to add candidates and delete members from
the SIM group by ID number.
Parameters add <candidate_id 1-100> <password> - Use this parameter to
change a candidate switch (CaS) to a member switch (MS) of a SIM
group. The CaS may be defined by its ID number and a password (if
necessary).
delete <member_id 1-32> - Use this parameter to delete a member
switch of a SIM group. The member switch should be defined by it ID
number.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add a member:
DES-6500:4#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK...
SIM Config Success !!!
Success.
DES-6500:4#
To delete a member:
246
