xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Max Age : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
Loopback Detection : Enabled
LBD Recover Time : 60
DES-6500:4#
show stp ports
Purpose Used to display the Switch’s current instance_id configuration.
Syntax
show stp ports <portlist>
Description This command displays the STP Instance Settings and STP
Instance Operational Status currently implemented on the Switch.
Parameters
<portlist> − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3
specifies slot number 1, port 3. 2:4 specifies slot number 2, port
4. 1:3-2:4 specifies all of the ports between slot 1, port 3 and slot
2, port 4 − in numerical order.
Restrictions None.
Example usage:
To show stp ports 1 through 9 on switch one:
DES-6500:4#show stp ports 1:1-1:9
Command: show stp ports 1:1-1:9
MSTP Port Information
----------------------
Port Index : 1:1 , Hello Time: 2 /2 , Port STP enabled , LBD: No
External PathCost : Auto/200000 , Edge Port : No /No , P2P : Auto /Yes
Msti Designated Bridge Internal PathCost Prio Status Role
----- ------------------ ----------------- ---- ---------- ----------
0 8000/0050BA7120D6 200000 128 Forwarding Root
1 8001/0053131A3324 200000 128 Forwarding Master
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show stp instance_id
Purpose Used to display the Switch’s STP instance configuration
Syntax
show stp instance_id <value 0-15>
Description This command displays the Switch’s current STP Instance
Settings and the STP Instance Operational Status.
Parameters <value 0-15> - Enter a value defining the previously configured
instance_id on the Switch. An entry of 0 will display the STP
86
