xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
create ospf aggregation
Purpose Used to configure OSPF area aggregation settings.
Syntax
create ospf aggregation <area_id> <network_address>
lsdb_type summary {advertise [enabled | disabled]}
Description This command is used to create an OSPF area aggregation.
Parameters
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the
OSPF Area.
lsdb_type summary − The type of address aggregation.
advertise [enabled | disabled] − Allows for the advertisement trigger
to be enabled or disabled.
Restrictions Only administrator-level users can issue this command.
Usage Example:
To create an OSPF area aggregation:
DES-6500:4#create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Command: create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
DES-6500:4#
delete ospf aggregation
Purpose Used to delete an OSPF area aggregation configuration.
delete ospf aggregation <area_id> <network_address>
lsdb_type summary
Description This command is used to delete an OSPF area aggregation
configuration.
Parameters
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to
the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation.
Restrictions Only administrator-level users can issue this command.
Syntax
Usage Example
To configure the OSPF area aggregation settings:
311
