![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/1/ff/1ff8d04a-ff4a-482a-beef-41201a3c7ef1/1ff8d04a-ff4a-482a-beef-41201a3c7ef1-bg37.png)
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
8
SWITCH UTILITY COMMANDS
The switch utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Parameters
[firmware_fromTFTP <ipaddr> <path_filename 64> unit
[all_line_card | cpu | <unitid 1-8>]} | cfg_fromTFTP <ipaddr>
<path_filename 64> {increment}
[cfg_toTFTP | log_toTFTP] <ipaddr> <path_filename 64>
Command
download
upload
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout
<sec 1-65535> | probe <value <1-9>
enable autoconfig
disable autoconfig
show autoconfig
Each command is listed, in detail, in the following sections.
download
Purpose Used to download and install new firmware or a switch
configuration file from a TFTP server or a CompactFlash memory
card.
Syntax
[firmware_fromTFTP <ipaddr> <path_filename 64> unit
[all_line_card | cpu | <unitid 1-8>]} | cfg_fromTFTP <ipaddr>
<path_filename 64> {increment}
Description This command is used to download a new firmware or a switch
configuration file from a TFTP server or a CompactFlash memory
card.
Parameters
firmware_fromTFTP − Download and install new firmware on the
Switch from a TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − The DOS path and filename of the
firmware or switch configuration file on the TFTP server. For
example, C:\3226S.had.
unit [all_line_card | cpu | <unitid 1-8>] − all specifies all
installed modules except the CPU module, cpu specifies the
chassis’ CPU module and <unitid> is the unit ID of a specific
installed module that will receive the download.
cfg_fromTFTP - Download a switch configuration file from a TFTP
server.
<ipaddr> − The IP address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − The DOS path and filename of the
firmware or switch configuration file on the TFTP server or
CompactFlash card. For example, C:\3226S.had.
52