xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show auth_diagnostics
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
To display the current authentication diagnostics for port 16:
DES-6500:4#show auth_diagnostics ports 1:16
Command: show auth_diagnostics ports 1:16
Port number : 1:16
EntersConnecting 0
EapLogoffsWhileConnecting 0
EntersAuthenticating 0
SuccessWhileAuthenticating 0
TimeoutsWhileAuthenticating 0
FailWhileAuthenticating 0
ReauthsWhileAuthenticating 0
EapStartsWhileAuthenticating 0
EapLogoffWhileAuthenticating 0
ReauthsWhileAuthenticated 0
BackendResponses 0
BackendAuthFails 0
EapStartsWhileAuthenticated 0
EapLogoffWhileAuthenticated 0
BackendAccessChallenges 0
BackendOtherRequestsToSupplicant 0
BackendNonNakResponsesFromSupplicant 0
BackendAuthSuccesses 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_session_statistics
Purpose Used to display the current authentication session statistics.
Syntax
show auth_session_statistics {ports [<portlist> | all]}
Description
The show auth_session statistics command is used to display
the current authentication session statistics of the Switch on a
per port basis.
Parameters
ports <portlist> − Specifies a range of ports. The port list is
specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies slot number 1, port 3. 2:4 specifies slot number 2, port
4. 1:3-2:4 specifies all of the ports between slot 1, port 3 and
slot 2, port 4 − in numerical order.
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
206
